NH Research 9200 Regenerative Battery Test System

pdf NH Research 9200 series Battery Module Pack Test System
pdf App note approaches to evaluate a charger
pdf App note testing without batteries


The 9200 Battery Test System is designed for all battery chemistries including  lead-acid, nickel-cadmium and lithium-ion. The 9200 is ideally suited for
applications where maximum tester configuration flexibility is needed to adapt to a broad range of battery voltage, current and power requirements now and in the  future. Another good fit is where high-speed set and measurement are necessary to better characterize battery transient performance. A third application is where  easier and faster test program creation is desired. All applications benefit from the 9200 discharge power recycling capability, which  results in both a cooler test environment and system cost recovery in a few years.

 

Programmable Bi-Directional Power


Each test channel is an 8 kW source, a 12 kW sink operates as a fully programmable power supply, load or battery. All of these operating modes support constant voltage, constant current and constant power regulation. More than one regulation made may be enabled at the same time, creating standard charge profiles like CCCV and CPCV.

 

Applications


The Battery Module/Pack Test System (9200 Series) is designed for all battery chemistries including lead-acid, nickel-cadmium and lithium-ion. This battery test system is ideally suited for applications where maximum tester configuration flexibility is needed to adapt to a broad range of battery voltage, current and power requirements now and in the future. Another good fit is where high-speed set and measurement are necessary to better characterize battery transient performance. A third application is where easier and faster test program creation is desired. all applications benefit from the 9200 discharge power recycling capability, which results in both a cooler test environment and system cost recovery in a few years. Other 9200 applications such as battery emulation, battery charger test and power supply burn-in are covered in supplemental product bulletins.

 

Features


  • Best configuration flexibility
  • Custom waveform/ profile generation
  • Microsecond voltage, current & mode transition times
  • Built-in digital measurements with charting & scope displays
  • 3 test system control options including a Touch-Panel interface
  • Expandable from 12 to 252 kW with 40, 120 or 600 V bi-directional DC loads
  • Regenerative, 87% efficiency of discharge power returned to AC mains
  • Multiple safety layers to protect battery being tested
  • Battery emulation and burn-in applications

More information


Please use the form below to request additional information.